Transfer Output Shaft (Hypoid Gear) Bearing Removal/Installation

Transfer Output Shaft (Hypoid Gear) Bearing Removal/Installation
Special Tools Required
- Driver, 40 mm I.D. 07746-0030100

1. Remove the tapered roller bearing (A) from the transfer output shaft (hypoid gear) (B) with a bearing separator (C) and a press. Place a shaft protector (D) between the transfer output shaft and a press to prevent damaging the shaft.





2. Install the 40 mm thrust shim (A) over the transfer output shaft (hypoid gear).





3. Install the tapered roller bearing over the transfer output shaft (hypoid gear) with the special tools and a press.