Power Switch Will Not Turn ON (No Information Display and No Sound)

Power switch will not turn ON (No information display and no sound)

NOTE:
- Check the vehicle battery condition first.
- Always check the connectors for poor connections or loose terminals.

1. Turn the ignition switch to ON (II).
2. With the ignition switch ON (II), push the power switch ON to see if audio unit turns ON.

Does the audio unit display operate properly, and does the audio unit sound normal?

YES - Intermittent failure, the system is OK at this time.

NO - Go to step 3.

3. Turn the ignition switch to LOCK (0).
4. Check the No. 5 (7.5 A) fuse and the No. 32 (10 A) fuse in the driver's under-dash fuse/relay box.

Are the fuses OK?

YES - Go to step 5.

NO - Replace the fuse, and recheck.

5. Remove the audio unit. Check that the audio unit is properly connected.

Is it connected properly?

YES - Go to step 6.

NO - Reconnect the connector, and recheck the function.

6. Disconnect audio unit connector A (20P).

NOTE: Eject all the CDs before removing the audio unit and CD changer to prevent damaging the CD player's load mechanism.

7. Turn the ignition switch to ON (II).
8. Measure the voltage between the No. 2 and No. 10 terminals of audio unit connector A (20P) and body ground.






Is there battery voltage?

YES - Go to step 9.

NO - Repair open in the wire(s) between the No. 5 (7.5 A) fuse and the No. 32 (10 A) fuse in the driver's under-dash fuse/relay box and the audio unit.

9. Turn the ignition switch to LOCK (0).
10. Reconnect audio unit connector A (20P).
11. Measure the voltage between audio unit connector A (20P) No. 20 terminal and body ground.






Is there less than 0.1 V?

YES - Replace the audio unit.

NO - Repair open in the wire between the audio unit connector A (20P) No. 20 terminal and body ground (G504).