Programming and Relearning

Keyless Access System and Immobilizer System Remote Registration and Reprogramming

Keyless Access System

Registration by the HDS is necessary when:

- Any of the remotes (A) are replaced.

- All of the remotes (A) are replaced.

- A new remote (A) is added.

- New remotes (A) are added.

- The keyless access control unit (B) is replaced.

- The ignition switch control unit (C) is replaced.

- The imoes unit (D) is replaced.

- Deleting the registration of a lost remote(s).

- The PCM is replaced.

NOTE: The keyless access control unit can store up to six remotes.






Immobilizer System

Registration by the HDS is necessary when:

- A built-in key (A) is added or replaced.

- The immobilizer control unit-receiver (B) is replaced.

- The imoes unit (C) is replaced.

- The PCM is replaced.

NOTE: The immobilizer control unit-receiver can store up to six built-in keys.






Registration

1. Turn the ignition switch to ON (II) with the built-in key.

2. Connect the HDS to the data link connector.

3. Select KEYLESS ACCESS or IMMOBILIZER (depending on the part replaced)* from the SYSTEM SELECT menu.
*: If registering the imoes unit, select IMMOBILIZER from the SYSTEM SELECT menu. (This is not necessary to register as a keyless access composed part.)

4. Enter the TEST MODE menu, then select the suitable menu from the HDS indications.