Speaker Test/Replacement

Speaker Test/Replacement

Front Door Speaker

1. Remove the front door panel. Front Door Panel Removal/Installation

2. Pull the speaker (A) straight out, just enough to release the upper clips. Then lift the speaker straight up to release the lower clips (B).
NOTICE:
If you pull the speaker out too far from the door, you will damage the lower clips.

3. Disconnect the 2P connector (C), and remove the speaker.

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 2 Ohms.

5. If the resistance is not as specified, replace the door speaker.






Rear Door Speaker

1. Remove the rear door panel. Rear Door Panel Removal/Installation

2. Remove the three mounting screws from the rear speaker (A).

3. Disconnect the 2P connector (B), and remove the rear door speaker.

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 2 Ohms.

5. If the resistance is not as specified, replace the door speaker.






Front Door Tweeter

1. Remove the front door sash inner trim. Front Door Sash Inner Trim Replacement

2. Remove the screws and tweeter speaker (A) from the quarter inner trim (B).

3. Measure the resistance between the front door tweeter 2P connector terminals No. 1 and No. 2. There should be about 3.6 Ohms.

4. If the resistance is not as specified, replace the front door tweeter.






Rear Twiddler

1. Remove the rear shelf. Service and Repair

2. Disconnect the 2P connector (A), then remove the connector (B) from the rear twiddler bracket (C).

3. Remove the screws and the rear twiddler (D).

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 4 Ohms.

5. If the resistance is not as specified, replace the rear twiddler speaker.






Front Center Speaker

NOTE:

- Put on gloves to protect your hands.

- Take care not scratch the dashboard.

1. Remove the dashboard upper visor (A).

2. Disconnect the connectors (B).






3. Remove the screws, connector (A), and the front center speaker (B).

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 4 Ohms.

5. If the resistance is not as specified, replace the front center speaker.






Subwoofer

1. Remove the rear shelf Service and Repair and rear shelf under cover.

2. Disconnect the 2P connector (A), then remove connector clip (B) from the subwoofer duct (C).

3. Remove the nuts and the subwoofer (D).

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 2 Ohms.

5. If the resistance is not as specified, replace the subwoofer.