Center Console Armrest Removal/Installation

Center Console Armrest Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

NOTE:

- Take care not to scratch the console.

- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

1. Remove the center console. Center Console Removal/Installation

2. Detach the clips, then remove the console trim (A). Disconnect the LF antenna connector (B) and the rear seat heater switch connectors (C) (if equipped).






3. Remove the screws (A) and detach the clips (B) and hooks (C), then remove the left console side trim (D) and the right console side trim (E).






4. Remove the screws, and release the tabs (A), then remove the console outlet trim (B).






5. Remove the screws, hinge bushings (A), and the hinge stoppers (B) from both sides, then remove the console armrest (C).

6. Remove the hinge springs (D) and the bushings (E) from both sides.

7. Install the armrest in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips into place securely.