Driver's Dashboard Undercover Removal/Installation

Driver's Dashboard Undercover Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

- Take care not to scratch the dashboard and related parts.

1. Remove the driver's dashboard undercover (A).
-1 Gently pull down the front edge to detach the clips (B, C).
-2 Disconnect the ambient light connector (D).
-3 Pull the cover away to release the pin (E) from the holder (F).

2. Install the cover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips into place securely.

- Make sure the holder of the cover is installed securely to the pin.