Turn Signal/Hazard Relay 1 Input Test

Turn Signal/Hazard Relay 1 Input Test

1. Remove the driver's dashboard undercover Driver's Dashboard Undercover Removal/Installation, and the driver's dashboard lower cover. Driver's Dashboard Lower Cover Removal/Installation

2. Remove the turn signal/hazard relay 1 (A) from the driver's under-dash fuse/relay box (B).

3. Inspect the relay and fuse/relay box socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.

- If the terminals look OK, go to step 3.

4. Do these input tests at the fuse/relay box.
- If any test indicates a problem, find and correct the cause, then recheck the system.

- If all the input tests prove OK, the turn signal/hazard relay 1 must be faulty; replace it.





*: Go to the B-CAN System Diagnosis Test Mode A. Troubleshooting - B-CAN System Diagnosis Test Mode A