Side Impact Sensor (First) Replacement

Side Impact Sensor (First) Replacement

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the front door sill trim Interior Trim Removal/Installation - Front Door Sill Area and the B-pillar lower trim panel. Interior Trim Removal/Installation - B-Pillar Lower Trim

3. Disconnect the floor wire harness 2P connector from the side impact sensor (first).

4. Using a TORX T30 bit, remove the TORX bolt (A), then remove the side impact sensor (first) (B).






Installation

1. Install the new side impact sensor (first) (A) with the TORX bolt (B), then connect the floor wire harness 2P connector (C) to the side impact sensor (first).

2. Do the battery terminal reconnection procedure. Procedures

3. Reinstall all removed parts.

4. After installing the side impact sensor (first), confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.