Front Impact Sensor Replacement

Front Impact Sensor Replacement

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Disconnect the driver's airbag 4P connector Service and Repair, the front passenger's airbag 4P connector Service and Repair, and both seat belt tensioner 2P connectors Service and Repair.

3. Remove the front bumper. Service and Repair

4. Disconnect the engine compartment wire harness 2P connector (A), and using a TORX T30 bit, remove the two TORX bolts (B), then remove the front impact sensor (C).






Installation

1. Install the new front impact sensor with new TORX bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C).

2. Reconnect the driver's airbag 4P connector, Service and Repair the front passenger's airbag 4P connector, Service and Repair and both seat belt tensioner 4P connectors. Service and Repair

3. Do the battery terminal reconnection procedure. Procedures

4. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.

5. Reinstall all removed parts.