Tightening Torques and Sequences

Cylinder head bolts





Measure the diameter of each cylinder head bolt at point A and point B
If either diameter is less than 10.6 mm (0.42 in.), replace the cylinder head bolt

FRONT





REAR





1st 29 N-m (3.0 kgf-m, 22 lbf-ft)
2nd 90°
3rd 90°
If you are using a new cylinder head bolt, tighten the bolt an extra 90 °

Injector Base





Tighten the injector base mounting bolts/nuts in a crisscross pattern in three steps, beginning with the inner nuts.

Intake manifold








Tighten the bolts and nuts sequentially in three steps

Camshaft pulley 90 Nm (9.2 kgf-m, 67 ft lb)