A/T Differential Carrier Bearing Replacement
A/T Differential Carrier Bearing Replacement
Special Tools Required
- Attachment, 45 x 55 mm 07MAD-PR90100
NOTE:
- The bearing and outer race should be replaced as a set.
- Inspect and adjust the bearing preload whenever the bearing is replaced.
- Check the bearing for wear and rough rotation. If the bearing is OK, removal is not necessary.
1. Remove the carrier bearing (A) with a commercially available bearing puller (B), bearing separator (C), and stepped adapter (D).
2. Install the new carrier bearings using the attachment (45 x 55 mm) and a press.
NOTE:
- Press the bearing on until it bottoms.
- Use the small end of the attachment (45 x 55 mm) to install the bearings.
- Press the bearing on securely so there is no clearance between the bearing and the differential carrier.