Operation CHARM: Car repair manuals for everyone.

Intermediary Shaft 3rd Gear Axial Clearance Inspection




Intermediary Shaft 3rd Gear Axial Clearance Inspection

Special Tools Required

- Driver, 40 mm I.D. 07746-0030100
1. Install the 3rd clutch (A), the original thickness 53 mm splined washer (B), thrust needle bearing (C), needle bearing (D), 3rd gear (E), and thrust needle bearing (F) on the intermediary shaft (G). Do not install the O-rings during inspection.

2. Install 4th gear (H) using the driver (40 mm I.D.) and the press.

3. Install the cotters (I), cotter retainer (J), and snap ring (K).











4. Set the dial indicator (A) on 3rd gear (B).






5. Measure the 3rd gear axial clearance in at least three places while moving 3rd gear. Use the average as the actual clearance.

Standard: 0.005-0.045 mm (0.0002-0.0018 in.)

6. If the clearance is out of standard, remove the splined washer and measure its thickness.

7. Select and install a new splined washer, then recheck the clearance.

SPLINED WASHER, 53 mm