Front Impact Sensor Replacement

Front Impact Sensor Replacement

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait at least 3 minutes before starting work.

2. Remove the front bumper. Service and Repair

3. Left side; removal the intake air resonator. Service and Repair

4. Disconnect the left or right engine compartment wire harness 2P connector (A) from the front impact sensor (B).

5. Remove the TORX bolts (C) using a TORX T30 bit, then remove the front impact sensor.






Installation

1. Install the front impact sensor (A) with a new TORX bolts (B), using a TORX T30 bit.

2. Connect the left or right engine compartment wire harness 2P connector (C) to the front impact sensor.

3. Do the battery terminal reconnection procedure. Procedures

4. Clear any DTCs with the HDS. Initial Inspection and Diagnostic Overview

5. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.

6. Reinstall all removed parts.