Brake System Indicator Does Not Go Off, and No DTCs Are Stored

Symptom Troubleshooting: Brake system indicator does not go off, and no DTCs are stored

Brake system indicator does not go off, and no DTCs are stored

1. Turn the ignition switch to ON (II).

2. Release the parking brake.

Does the brake system indicator go off after several seconds?
YES - The system is OK at this time. Refer to intermittent failures. Reading and Clearing Diagnostic Trouble Codes

NO - Go to step 3.


3. Check the brake fluid level. Service and Repair

Is the level OK?
YES - Go to step 4.

NO - Inspect the brake system for fluid leak. If no leaks are found, replace all worn brake pads.


4. Check the ABS indicator.

Does the ABS indicator stay on?
YES - Read the DTC, Reading and Clearing Diagnostic Trouble Codes and do the applicable troubleshooting for the DTC.

NO - Check the brake system indicator circuit:

- Short to body ground between the gauge control module and the parking brake switch.

- Short to body ground between the gauge control module and the brake fluid level switch.

- Parking brake switch stuck ON.

- Brake fluid level switch stuck ON.

- Faulty gauge control module.