Driver/Vehicle Information Display: Service and Repair

Multi-information Display Select/Reset/Information Switch Test/Replacement

NOTE: SRS components are located in this area. Review the SRS component locations Locations, and precautions and procedures Service and Repair before doing repairs or servicing.

1. Remove the driver's airbag assembly Driver's Airbag Replacement.

2. Disconnect the 7P connector (A) from the select/reset/information switch (B).





3. Remove the screws and the switch.

4. Measure the resistance between select/reset/information switch 7P connector terminals No. 2 and No. 6 in each switch position according to the table.









5. If the resistance is not as specified, replace the switch.

6. If the switch is OK, but there is a problem with the switch function, check the steering switches harness and cable reel.