Trunk / Liftgate: Adjustments

Tailgate Adjustment

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. With power tailgate: Do the battery terminal disconnection procedure, then wait at least 3 minutes before beginning work.

NOTE: Open the tailgate by using the emergency lever while adjusting the tailgate:

- Without power tailgate
- With power tailgate

2. Remove these items:

- Tailgate weatherstrip Service and Repair
- Quarter pillar trims, both sides
- Tailgate support struts, both sides Tailgate Support Strut Replacement

3. Slightly loosen each nut and screw.

4. Adjust the tailgate (A) alignment in the following sequence:

- Adjust the tailgate hinges (B) right and left, as well as forward and rearward, by using the elongated holes in the hinges.
- Turn the tailgate edge cushions (C), in or out as necessary, to make the tailgate fit flush with the body at the side edges.
- Adjust the fit between the tailgate and tailgate opening by moving the striker (D), and pull the striker cap (E) up, then adjust the striker right or left until it is centered in the tailgate latch (F).





5. Tighten each nut and screw securely.

6. Check that the tailgate opens properly and locks securely.

7. Reinstall the support struts securely.

8. Apply touch-up paint to the hinge mounting bolts and around the hinges, and let the paint dry.

9. Reinstall all of the removed parts.

10. With power tailgate: Do the battery terminal reconnection procedure.