No Heat Setting Up to and Including 84~F (23~C)

SEALING GASKETS:

- remove water tray from air plenum in engine compartment
- remove yellow 4 point connector from evaporator
- remove both seaiing gaskets (A) from connector housing with small screwdriver
- cut off rubber tubes (arrows) of sealing gasket

CAUTION

Do not damage wire insulation when removing rubber tubes

- push sealing gaskets into connector housing
- reconnect connector
- install water tray over air plenum

- test climate control regulation at settings from 60~F (15~C) to 84~F (29~C)