Ignition Switch, Removing and Installing

Ignition Switch, Removing And Installing

Removing

NOTE: It is not necessary to remove the lock cylinder.

- Disconnect battery Ground (GND) strap.
- Remove driver's-side airbag unit and steering wheel.
- Remove steering column switches.
- Disconnect harness connector from ignition/starter switch.







- Remove sealing paint from threads of screws -A-.
- Loosen two screws (arrows -A-) slightly and pull ignition/starter switch out of housing in direction indicated (arrow).

Installing

NOTE:
- The ignition switch and lock cylinder must be in the same position, e.g. "Ignition on" when installing.
- Seal the screws with paint after installing.

- Install in reverse order of removal.