DTC Memory, Erasing (Scan Tool Function 05)

DTC Memory, erasing (scan tool function 05) - 5 Spd. Automatic Transmission 01V

Requirement:

^ DTC memory checked.

After DTC memory has been checked:

Rapid data transfer HELP
Select function XX

Indicated on display:

- Press keys 0 and 5. (With function 05 "Erase DTC memory" is entered)

Rapid data transfer Q
05 Erase DTC memory

Indicated on display:

- Confirm entry with Q button.

WARNING!
DTC memory was not checked

Indicated on display:

Note:
If the ignition was switched off e.g. between checking the DTC memory and erasing DTC memory the DTC memory is then not erased.

- Exactly follow the work sequence. The DTC memory must first be checked.

Rapid data transfer ->
DTC memory is erased!

Indicated on display:

(The DTC memory will be erased approx. 5 seconds. after the display appears.)
The DTC memory is now erased.

Note:
Wait about I minute before checking the DTC memory again.

System cannot be checked!

Indicated on display:

1 Fault recognized!
00811 3333
System cannot be checked

Print out with printer switched on:

Transmission Control Module (TCM) -J217- was not given sufficient time to recognize faults.

- Wait about 1 minute before checking the DTC memory again.
- After checking and erasing DTC memory, test drive the car and check DTC memory again.

When the DTC memory is being checked, the following display should appear:

"No DTC recognized!"