Wiper Arm: Service and Repair
Rear Windshield Wiper, Removing And Installing
NOTE: Make sure that wiper motor is in park position before removing wiper arm.
1 - Connection line
- For spray jet
2 - Securing nut - 12 Nm
3 - Spray jet
4 - Rear wiper cap
5 - Wiper arm
6 - Wiper blade
Removing
- Carefully pry off cap -4- using a small screwdriver.
- Carefully pull off spray jet -3- from connection line.
- Remove securing nut -2-.
- Remove wiper arm -5- from shaft drive.
Installing
Installation is the reverse order of removal while observing the following:
- Switch rear windshield wiper on and off and let it run to park position.
- Set wiper arm -5- with wiper blade -6- onto shaft drive.
- Adjusting wiper blade at rear windshield.
- Secure wiper arm with nut -4- (12 Nm).
- Operate rear windshield wiper.
- If necessary, adjust wiper arm once again and tighten securing nut.