Safety Regulations For Handling Pyrotechnic Belt Tensioners
Safety Regulations For Handling Pyrotechnic Belt Tensioners
- Testing, removing, installing and repair work may only be performed by qualified personnel.
- When connecting belt tensioner module, all mechanical parts (including those of three-point seat belt) must be properly attached.
- Other than person performing work, there should be no - one in vehicle.
- Belt tensioner components may neither be opened nor repaired; always use new parts.
- Belt tensioner modules which have been dropped from a height of more than 50 cm must not be installed in a vehicle.
- Belt tensioner modules which are mechanically damaged (dents, fractures) must be replaced.
- Belt tensioner modules are to be installed immediately following removal from transportation container.
- If work is interrupted, belt tensioner module must again be placed in its transport container.
- Never point open end of belt tensioner at another person.
- Always wash hands after handling belt tensioners which have been activated.
- Storage and transportation are subject to legislation for explosive substances.
- Belt tensioner modules are never to be left unattended.
- Belt tensioner module must not be treated with grease, cleaning agents or similar, nor may it be exposed to temperatures above 212 degrees F (100 degrees C), even for short periods.