Rear Brakes With Electronic Parking Brake

Rear Brakes with Electronic Parking Brake

Rear wheel brake with automatic adjustment.

• Only install the complete repair set.






1 - Self-Locking Bolt

• 12 Nm

2 - Electromechanical Parking Brake Actuator

• Electromechanical parking brake control module, removing and installing => [ Electro-Mechanical Parking Brake Control Module J540 ] Service and Repair

• Actuator, removing and installing => [ Electro-Mechanical Parking Brake Actuator ] Service and Repair

3 - Seal

• Always replace.

4 - Self-Locking Bolt

• 35 Nm

• Always replace.

• When loosening and tightening, counter-hold at guide pin

5 - Spacer

6 - Brake Hose

• In brake caliper, 20 Nm

• Do not disconnect brake line when changing brake pads

• Make sure that retaining tabs are seated correctly in bracket.

• Install hose without twisting

7 - Brake Caliper Housing

• Do not remove the brake hose when changing the brake pads.

• Brake caliper, servicing

• it is possible to install brake carrier with brake caliper

• Removing and Installing => [ Rear Brake Caliper with Brake Carrier ] Rear Brake Caliper With Brake Carrier

• Replace => [ Rear Brake Caliper ] Rear Brake Caliper

8 - Brake Carrier with Guide Pins and Cap

• Supplied as an assembled replacement part with sufficient grease on guide pins

• If protective caps or guide pins are damaged, install repair kit. Use grease packet supplied to lubricate guide pins

• it is possible to install brake carrier with brake caliper

• Removing and Installing => [ Rear Brake Caliper with Brake Carrier ] Rear Brake Caliper With Brake Carrier

9 - Brake Pads

• Wear limit => [ Brakes ] Brakes

• Must always be replaced together on both sides of axle

• Removing and Installing => [ Rear Brake Pads ] Rear Brake Pads

• it is possible to install brake carrier with brake caliper

• The brake pads must be seated between both securing tabs on the pad retaining plate to provide the air gap between the brake disc and brake pad.

10 - Brake Pad Retaining Plate

• Always replace when pads are replaced

• The brake pads must be seated between both securing tabs on the pad retaining plate to provide the air gap between the brake disc and brake pad.

11 - Wheel Bolts

12 - Bolt

• 5 Nm

13 - Brake Rotor

• Wear limit => [ Brakes ] Brakes

• Removing and Installing => [ Rear Brake Disc ] Rear Brake Disc

• Must always be replaced together on both sides of axle

• Brake rotor allocation => [ Brakes ] Brakes

14 - Hex Head Bolts

• 10 Nm

15 - Brake Shield

• Removing and Installing => [ Rear Brake Shield ] Rear Brake Shield

16 - Bolt

• 100 Nm + 90°

• Replace

17 - Bolts

• 100 Nm + 90°

• Replace