Heads Up Display Unit: Service and Repair

Windshield Projection Head Up Display Control Module (J898)

Danger of causing damage.

• Remove only the marked screws from the windshield projection head up display control module.

• The windshield projection head up display control module must be replaced if the screws are removed from the housing upper section.

• If the windshield projection head up display control module should fall down it must be replaced because the inner components will get damaged even though there is no damage on the outside.

• Do not place any force on the housing upper section for the windshield projection head up display control module otherwise the windshield projection head up display control module will have to be replaced.

Removing






- Remove the upper cover..

- Cover the control module - 3 - with a soft towel.

- Remove the windshield.

- Remove the bolts - 1, 2 and 5 -.

- Lift the control module slightly and disconnect the connector - 4 -.

- Remove the control module.

Installing

• Tightening specification, refer to => [ Windshield Projection Control Module Overview ] Windshield Projection Control Module Overview.

Install in reverse order of removal. Note the following:

- Install the control module and tighten the screws.

- Mount the windshield and secure it - do not bond it.

- Turn on the ignition and check the control module function.

• A number must be appear on the windshield.

- Install the windshield.

- Install the upper instrument panel cover.

- Calibrate the windshield projection control module. Refer to => [ Windshield Projection Head Up Display Control Module (J898), Calibrating ] Testing and Inspection.

- Install the windshield projection control module cover.