PROM - Programmable Read Only Memory: Technical Service Bulletins

• Recalls
  • Campaign - DME Programming for Electric Fan Activation
  • Campaign - DME Programming for Low Oil level Indicator
• Customer Interest
  • Engine Controls - Charge Lamp ON/Code 281D Set
  • Engine Controls - Temp Gauge Goes To Red/No Overheat
  • A/T Controls - Harsh 3-2 and 2-1 Downshifts
  • Engine Controls - Engine Power Drop At 4,000 RPM
  • Engine Controls - MIL ON/O2 Sensor Fault Codes Stored
  • Engine Controls - SES Lamp ON/DTC's 2896/2877/2766 Set
• All Technical Service Bulletins
  • Computers, Controls - Programming VS Veh. Data Status
  • Engine Controls - DME Programming Tips
  • Progman(R) - Programming/Coding/Individualization
    • Overview
    • General_Rules_For_Programming
    • Procedure_A_Module_Replacement
    • Procedure_B_Software_Update
    • Procedure_C_Troubleshooting
      • Index
      • Introduction
      • Section I: Preparing A Progman Session
      • Section II: Progman Session Initialization
      • Section III: Before Programming/Coding
      • Section IV: After Programming Coding
      • Illustrations and Table
    • Procedure_E_Coding
  • Computers/Controls - 'Retrofit' Update Programming
  • Engine Controls - Charge Lamp ON/Code 281D Set
  • Engine Controls - Temp Gauge Goes To Red/No Overheat
  • A/T Controls - Harsh 3-2 and 2-1 Downshifts
  • Engine Controls - Engine Power Drop At 4,000 RPM
  • Computers/Controls - Progman(R) V22.0/V22.0.1 Errors
  • Engine Controls - Progman(R) V21.01 and V21.02.01 Errors
  • Engine Controls - MIL ON/O2 Sensor Fault Codes Stored
  • Engine Controls - SES Lamp ON/DTC's 2896/2877/2766 Set
  • Campaign - DME Programming for Electric Fan Activation
  • Campaign - DME Programming for Low Oil level Indicator