Center Mounted Brake Lamp: Service and Repair

Removing And Installing/Replacing Additional Stop Light







Open Trunk Lid
Loosen screws (1).
Feed out cover (2) in direction of arrow, unlock plug connection of auxiliary brake light behind it and disconnect.
Pay attention to springs underneath when releasing nuts (3).

Installation:
Tightening sequence of screws:
1. Middle
2. Outer

Tightening torque, 2.5 ± 0.5 Nm.







Pull auxiliary brake light (1) in direction of arrow out of rear lid (2) and remove.

Installation:
Make sure auxiliary brake light seal is correctly seated.
If necessary, replace auxiliary brake light seal.