DTC 41

DTC 41 Right Front ESB Will Not Hold Motor:

Circuit Description:
This DTC is designed to detect a slipping right front ESB. During initialization and braking, the right front motor is re-homed. If the ESB slips, the motor/piston will move. During the next ABS initialization, a re-home of the motor verifies the motor/piston remained at the home position. If motor movement is detected, the ESB must be slipping.

DTC Will Set When:
DTC 41 can be set during initialization. DTC 86 is always set with DTC 41.

Action Taken:
If an ESB cannot hold a motor in the home position, the motor may be back driven when the brake pedal is applied causing the brake pedal to drop. A malfunction DTC is stored, ABS is disabled and the ABS indicator lamp is turned "ON."

DTC Chart Test Description:
Number(s) below refer to circled number(s) on the diagnostic chart.
1. This step ensures motor circuits are in the proper connector cavity.
2. This step checks the right front ESB. A broken or defective ESB would result in the rear piston being back driven by hydraulic pressure, and wheel movement would result.
3. Checks for high resistance in the right front motor high circuit.
4. Checks for high resistance in the right front motor low circuit.
5. Checks for excessive resistance in the right front motor.
6. Ensures malfunction was not due to a poor connection.

Diagnostic Aids:
An "intermittent" malfunction in this DTC may result from a mechanical part of the system that sticks, binds, or slips.

The frequency of the malfunction can be checked by using the enhanced diagnostic function of the Tech 1.