Troubleshooting Hints

PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS
NOTE: If the vehicle is left for 24 or more days without the ignition being put in the "RUN" position, the Illuminated Entry Feature will be disabled to decrease parasitic battery drain. Putting the ignition switch in "RUN" will restore this feature.

1. Check that ground G302 is clean and tight.
2. Check the DR LK1 Fuse by operating the Power Door Locks.
3. Always check terminal contact before replacing any component.
4. If a second transmitter is available, try it. If it works, resynchronize the first transmitter and try it again. If still not operational, change the batteries in transmitter. If still not operational, replace the transmitter.
5. Check Transmitter battery terminals. They should be clean and make good contact with the battery.
6. If in doubt as to the condition of the Transmitter batteries, replace them with new ones. Checking the battery voltage with a DVOM may give false results.
7. If a motor's internal circuit breaker trips, it will not reset until voltage is removed from the motor.
^ Refer to Remote Control Door Lock Receiver Access and additional information.
^ Refer to System Diagnosis.
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a continuity/voltage check (refer to Troubleshooting Procedures).
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems (refer to Troubleshooting Procedures). Diagnostic Aids