P1640
DTC P1640
CIRCUIT DESCRIPTION
The output driver module (ODM) is a control chip inside of the powertrain control module (PCM). The PCM contains multiple ODMs. ODMs provide grounded output control of devices. Each ODM output has an internal feedback circuit that connects to the PCM microprocessor. The PCM monitors voltage through the ignition 1 voltage circuit. Excessive voltage or current may cause damage to the PCM. If the ODM detects excessive current or voltage on an output control circuit, this diagnostic trouble code (DTC) will set.
DTC DESCRIPTOR
This diagnostic procedure supports the following DTC:
- DTC P1640 Control Module Output A Circuit
CONDITIONS FOR RUNNING THE DTC
The ignition is in Run or Crank.
CONDITIONS FOR SETTING THE DTC
- The ODM has detected a voltage greater than 33 volts. OR
- Excessive current is detected on any circuit to the ODM.
- The conditions are present for at least 30 seconds.
ACTION TAKEN WHEN THE DTC SETS
- The control module stores the DTC information into memory when the diagnostic runs and fails.
- The malfunction indicator lamp (MIL) will not illuminate.
- The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records.
- The driver information center, if equipped, may display a message.
CONDITIONS FOR CLEARING THE DTC
- A current DTC Last Test Failed clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Clear the DTC with a scan tool.
DIAGNOSTIC AIDS
- A condition with the charging system may cause this DTC to set. Refer to Charging System Test in Starting and Charging. Component Tests and General Diagnostics
- For an intermittent condition, refer to Intermittent Conditions. Intermittent Conditions
TEST
