Scan Tool Data Definitions

Scan Tool Data Definitions

Instrument Panel Module (IPM)
Steering Wheel Controls Return
- The scan tool displays the number of counts corresponding to the signal of the switch pressed.

Battery Voltage Signal
- The scan tool displays the battery voltage. The battery voltage input represents the system voltage measured at the module ignition feed input.

Accessory, Run, or Run/Crank Relay Status
- The scan tool displays the status of the respective relay.

Start, Accessory, or OFF LED Duty Cycle
- The scan tool displays the percentage of the pulse width modulation (PWM) control signal of the respective LED.

Rear Integration Module (RIM)
Battery Voltage Signal
- The scan tool displays the battery voltage. The battery voltage input represents the system voltage measured at the module ignition feed input.

Run/Crank Terminal Status
- The scan tool displays the status of the respective input.

Sunroof Enable Command
- The scan tool displays the status of the respective output.

Remote Control Door Lock Receiver (RCDLR)
Battery Voltage Signal
- The scan tool displays the battery voltage. The battery voltage input represents the system voltage measured at the module ignition feed input.

Ignition Mode Switch
- The scan tool displays the voltage and the state read by the module from the ignition mode switch.

Ign. Mode Sw. Dimming Command
- The scan tool displays the status of the ignition mode switch dimming.

Ignition Switch Fault
- The scan tool displays if the remote control door lock receiver (RCDLR) detected a fault on the ignition mode switch signal circuit.

Invalid Power Moding
- The scan tool displays if the RCDLR detects an invalid power moding.

Back up Power Moding
- The scan tool displays if back up power mode is active or not.

Run/Crank Relay Command
- The scan tool displays if the run/crank relay is controlled or not by the module.

Run/Crank Relay Status
- The scan tool displays the run/crank relay status.

Driver/Passenger Door Module (DDM/PDM)
Door Ajar Switch
- The scan tool displays the status of the respective door switch.