Operation CHARM: Car repair manuals for everyone.

Headlamp Washer Spray Nozzle: Service and Repair




Headlamp Washer Nozzle Replacement

Removal Procedure




1. Remove the fasteners (1, 3) and push-pins (2) from the forward wheelhouse splash shield (4) to access the underside of the bumper cover.




2. Slide the hose lock connector (4) at the headlamp washer (2). Disconnect the hose.
3. Remove the retaining clip (3) from the headlamp washer.
4. Remove the headlamp washer (2) from the topside of the bumper cover (1).

Installation Procedure

1. Install the headlamp washer to the topside of the bumper cover.





Note: Ensure that the detent on the retaining clip snaps into the fully seated position.

2. Install the retaining clip (3) to the headlamp washer (2) at the underside of the bumper cover (1).
3. Connect the hose to the headlamp washer. Slide the lock connector (4) to the closed position.





Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the wheelhouse splash shield (4) and fasteners (1, 2, 3) to the forward part of the wheelhouse and tighten to 2 Nm (18 lb in).
5. Inspect the washer for leaks. Verify the operation of the washer.