Parts Information

The correct quantity of parking brake lever assemblies is being shipped to each dealer with vehicles involved on a "NO CHARGE" basis. They WILL NOT BE billed on dealer parts account. Dealers should not order from GMWDD. If transfers make additional parts necessary, contact your zone office.

Replaced parts are to be retained for disposition by zone personnel.



SERVICE PROCEDURE (Refer to Figure 1)

1. Block wheels to prevent car from rolling.

2. Place gear selector in neutral.

3. Loosen parking brake cable at adjuster nut to allow cable to be disconnected from lever assembly.

4. Remove front ashtray and two screws located below ashtray.

5. Remove snap ring retaining shift knob and remove shift knob.

6. Remove trimplate by pulling front end up first.

7. Remove three screws under trimplate.

8. Remove rear ashtray and screws under ashtray, and lift off console.

9. Remove parking brake switch.
SERVICE PROCEDURE

10. Remove parking brake cable from lever assembly.

11. Remove three bolts securing lever to floor pan and remove lever.

12. Install new parking brake lever assembly and tighten attaching bolts to 25 N-M (18 ft.lbs.).

13. Reverse steps 1 through 10.

14. Apply parking brake lever exactly 5 ratchet clicks.

15. Raise car on hoist.

16. Check to make sure equalizer adjuster nut groove is liberally lubricated with grease.

17. Tighten adjusting nut until right rear wheel can be turned rearward using two hands but is locked when forward rotation is attempted.

18. With parking brake lever mechanism totally disengaged, rear wheels must turn freely in either direction with no brake drag.

19. Lower Car.

20. Install Campaign Identification Label.

CAMPAIGN IDENTIFICATION LABEL:

CAMPAIGN IDENTIFICATION LABEL

Each vehicle modified in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label." Each label provides a space to include the five digit dealer code of the dealer performing the campaign service. This information may be inserted with a typewriter or ballpoint pen.

Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in for periodic servicing by the owner.

Apply "Campaign Identification Label" only on a clean dry surface.
CLAIM INFORMATION

Submit a Product Campaign Claim with the information indicated below:


*

FAILED PARTS LABOR LAB OTH
REPAIR PERFORMED PC PART NO. ALLOW FC OP HRS HRS

^ REPLACE PARKING BRAKE LEVER ASSY. 1 22534843 ** 00 V3600 .6 .1


*Campaign Administrative Allowance.

**The "Parts Allowance" should be 30% of the current GMWDD Dealer Net price when parts are furnished no charge by Chevrolet.

Dealers will automatically receive the correct labor and material allowance based on the labor operation performed.

Refer to the Chevrolet Claims Processing Manual for details on Product Campaign Claim submission.