Wiring Harness

Fig. 27 Wiring harness & relays:

1. Disconnect battery ground cable.
2. Remove storage tray and insulation.
3. Disconnect control module harness connector by depressing spring clip located under neck of connector, Fig. 27.
4. Remove two screws from modulator valve harness retainer, then disconnect harness connector.
5. Disconnect battery feed harness connector.
6. Disconnect wheel speed sensor and body harness connector.
7. Remove module relay from control module bracket, then disconnect modular relay harness connector.
8. Reverse procedure to install. Ensure all connectors are securely connected.