Rear Suspension

Cover Beam to Body 135 Nm (100 lb ft)
Support Beam to Diff. Carrier 80 Nm (60 lb ft)
Support Beam to Transmission 70 Nm (35 lb ft)
Trunnion Straps at Side Gear Yoke 35 Nm (26 lb ft)
Trunnion Straps at Spindle Yoke 35 Nm (26 lb ft)
Spindle to Hub and Bearing 222 Nm (164 lb ft)
Hub and Bearing to Knuckle 90 Nm (66 lb ft)
Dust Shield to Backing Plate 10 Nm (7 lb ft)
Shock Absorber Stud to Knuckle Nut 120 Nm (80 lb ft)
Shock Absorber to Body 90 Nm (66 lb ft)
Shock Absorber to Knuckle 88 Nm (65 lb ft)
Control Arms to Body 85 Nm (63 lb ft)
Control Arms to Knuckle 190 Nm (140 lb ft)
Jounce Bumper to Body 47 Nm (35 lb ft)
Cam Bolt to Support Rod 252 Nm (186 lb ft)
Support Rod to Knuckle 145 Nm (107 lb ft)
Support Rod Bracket to Diff. Carrier 75 Nm (55 lb ft)
Tie Rod End to Knuckle 45 Nm (33 lb ft)
Tie Rod End Locking Nut 63 Nm (46 lb ft)
Tie Rod Housing to Cover Beam 74 Nm (54 lb ft)
Stabilizer Bar to Body 25 Nm (18 lb ft)
Stabilizer Link to Bracket and Bar 52 Nm (38 lb ft)
Stabilizer Link Bracket to Knuckle 25 Nm (18 lb ft)
Underbody Brace (Model 67)
Nuts 25 Nm (18 lb ft)
Bolts 65 Nm (48 lb ft)
Transverse Spring to Cover Beam 50 Nm (37 lb ft)
Transverse Spring Link Bolt to Knuckle: Snug up nut. Then only necessary torque required to install cotter pin. DO NOT back off nut.