Cruise Control Adjustment Procedures

RELEASE SWITCHES
Automatic Transmission
Both the electrical and vacuum release switches are located at the brake pedal. To adjust, depress brake pedal and insert switch fully into tubular clip. Pull pedal rearward until clicking sounds are no longer audible. The switch is now automatically adjusted.Manual Transmission
On manual transmission equipped vehicles, the electrical release switch is located at the clutch pedal, while the vacuum release switch is found at the brake pedal. Adjustment procedures for these switches are the same as for those under automatic transmission equipped vehicles.
SERVO, ADJUST
With engine off and throttle valve in slow idle position, insert cable end pin in closest hole in servo tab assembly without tensioning cable. If no holes line up, move cable away from servo assembly until next closest hole lines up. After installing cable end pin in servo tab, install pin retainer.

CRUISE SPEED, ADJUST
The cruise speed cannot be adjusted. If cruise speed is lower or higher than engagement speed, the cruise control module should be replaced.