Owner, Dealer, and Parts Information

OWNER NOTIFICATION
OWNERS WILL BE NOTIFIED OF THIS CAMPAIGN ON THEIR VEHICLES
BY CHEVROLET MOTOR DIVISION. (SEE COPY OF OWNER LETTER
INCLUDED WITH THIS DCS).


DEALER CAMPAIGN RESPONSIBILITY

DEALERS ARE TO SERVICE ALL VEHICLES SUBJECT TO THIS CAMPAIGN AT NO CHARGE TO OWNERS, REGARDLESS OF MILEAGE, AGE OF VEHICLE, OR OWNERSHIP, FROM THIS TIME FORWARD.

WHENEVER A VEHICLE SUBJECT TO THIS CAMPAIGN IS TAKEN INTO YOUR NEW OR USED VEHICLE INVENTORY, OR IT IS IN YOUR DEALERSHIP FOR SERVICE IN THE FUTURE, YOU SHOULD TAKE THE STEPS NECESSARY TO BE SURE THE CAMPAIGN CORRECTION HAS BEEN MADE BEFORE RESELLING OR RELEASING THE VEHICLES.

OWNERS OF VEHICLES RECENTLY SOLD FROM YOUR NEW VEHICLE INVENTORY ARE TO BE CONTACTED BY THE DEALER, AND ARRANGEMENTS MADE TO MAKE THE REQUIRED CORRECTION ACCORDING TO INSTRUCTIONS CONTAINED IN THIS DCS.

PARTS INFORMATION

NO PARTS ARE REQUIRED TO COMPLETE THIS CAMPAIGN.

SERVICE PROCEDURE

1. OPEN HOOD AND LOCATE FOG LAMP WIRING HARNESS (FRONT OF VEHICLE NEAR THE FORWARD LAMP HARNESS).

2. INSPECT HARNESS FOR ANY SIGNS OF ABRASION. IF THE HARNESS IS ABRADED, REPAIR ABRADED AREAS OF THE HARNESS AS REQUIRED (TAPE, ETC.)

3. TUCK FOG LAMP WIRING INTO EXISTING WIRING CONDUIT (RUNNING ACROSS TOP OF RADIATOR CORE SUPPORT) AND APPLY TAPE AT BREAKOUT TO ENSURE THAT WIRING DOES NOT WORK FREE.

4. ZIP TIE ("CHICKEN BAND") REMAINING WIRE TO RADIATOR CROSS-BAR TO KEEP AWAY FROM BRACKETS AND OTHER OBSTACLES.

5. INSTALL CAMPAIGN IDENTIFICATION LABEL.