Station (ACR) Setup and Maintenance

STATION (ACR) SETUP AND MAINTENANCE

Filter Drier Installation

NOTICE USE ONLY AUTHORIZED FILTER DRIER CORES. Use of any other cores will give unsatisfactory results and will void the warranty.

1. Remove the screws holding the filter cap to the shell. Inside you will find a filter drier core bracket (attached to the cap), and a piece of cardboard separating the bracket and the filter cap.
2. Clean all internal parts with a lint free towel.
3. Discard the cardboard separator.
4. Remove the filter drier core from the sealed can. Do not remove the filter from the can until you are ready to install it in the system.
5. If the filter cap gasket is damaged, replace it. Replacement gaskets are included with each filter drier core.
6. Center the spring on the filter cap and place the upper bracket on the spring with the center boss of the bracket fitting into the coil and the edges of the plate facing up.
7. Position the filter drier core on the upper bracket. Position the screened lower bracket on the filter drier core and install the tie rods. Tighten the tie rods until they stop.
8. Install the filter drier core assembly into the filter drier shell. Replace the bolts and tighten in a star pattern to a torque of 20 Nm (15 lbs. ft.).
9. When the core has been installed and the filter drier reassembled, attach the blue hose to the vacuum pump and start the vacuum pump. Run the pump for approximately 10 minutes to remove all air.
10. Turn off the vacuum pump and disconnect the hose.