Turn Signals: Description and Operation

With the Ignition Switch in "RUN," "BULB TEST," or "START," voltage is applied through Fuse 5 and the Turn Flasher to the normally closed contact of the Hazard Switch in the Turn/Hazard Switch.

With the Turn Switch in the "LEFT" position, voltage is applied to both the LH Turn Indicator and the LH Front Park/Turn Light (CKT 14). Voltage is also applied to the LH Tail/Stop-Turn Light (CKT 18). The lights go on immediately. They begin to flash when the current flow heats up the timing element in the Turn Flasher and it repeatedly opens and closes the circuit.

The voltage applied to the LH Front Park/Turn Light will also be applied to the LH Front Side Marker Light. If the Headlight Switch is "OFF," the LH Front Side Marker Light will find a path to ground through the Front Park/Turn Light. These lights provide low resistance paths to ground. The Marker Light will flash with the Turn Lights. The lights used for the ground path will not flash, however, since the voltage drop across the Marker Light is much higher than that across the other lights.

When the Headlight Switch is in either "PARK" or "HEAD," voltage is applied through Fuse 7, the Light Switch, and to the Marker and Park Lights. If the Turn Switch is in "LEFT," the LH Front Side Marker Light will have voltage at both connections and will not light. When the Turn Flasher stops voltage to the Front Park/Turn Light, the Marker Light will be grounded through the Turn Light and will go on. In this way, the LH Front Side Marker Light will flash on when the LH Front Park/ Turn Light goes off, and off when the Turn Light goes on.

With the Turn Switch in "RIGHT," voltage is applied to the RH lights in a similar way.