Ignition System: Service and Repair

Ignition Module Assembly Replacement:

REMOVAL

1. Disconnect negative battery cable.
2. Disconnect DIS electrical connectors.
3. Disconnect spark plug wires. (Note proper relationship of wires to coils).
4. Remove DIS assembly to block bolts (3).
5. Remove DIS assembly from engine.


INSPECT

^ Crankshaft sensor O-ring for wear, cracks, or leakage. Replace if necessary. Lube O-ring with engine oil before installing.




INSTALLATION

1. Install DIS assembly to engine.
2. Install DIS assembly to block bolts (3). Torque to 27 N-m (20 lbs ft).
3. Connect spark plug wires to proper coils.
4. Connect DIS electrical connectors.
5. Connect negative battery cable.