Windows: Description and Operation

CONSOLE WINDOW SWITCH
With the ignition Switch in "RUN," battery voltage is applied to the Console Window Switch via CKT 76. The switch assembly is grounded via CKT 150. When any Console Window Switch "UP" switch not associated with express down is operated, battery voltage is applied to the Window Motor. The motor is grounded through the "DN" contact in the Console Window Switch, and it runs to drive the window up.

When a Console Window Switch "DN" switch is pressed past the first detent, battery voltage is applied to the Window Motor in the opposite direction. The motor is grounded though the "UP" contact in the Console Window Switch, and it runs to drive the window down.

EXPRESS DOWN FEATURE
When the LH front window switch is pressed to first detent in the "DN" position, the express down circuit within the Console Window Switch engages and applies voltage to CKT 165. The LH front window moves to the fully open position. When the LH front window reaches its mechanical limit, the current draw to this motor increases significantly. The express down circuits in the Console Window Switch sense this current draw and remove power to the Window Motor.

REAR WINDOWS
The Rear Window Switches are tied in a series circuit to the Console Window Switch. At rest, each switch contact is tied to ground through the Console Window Switch. When the master switch is operating a rear window, battery voltage is applied to one side of the associated Rear Power Window Motor. The motor drives the window in the corresponding direction.

When a Rear Window Switch is operated, battery voltage is applied to the Rear Power Window Motor through CKT 76. The motor drives the window in the corresponding direction.

Each motor is protected by a built-in electronic circuit breaker PTC. if a Window Switch is held too long with the window obstructed or after the window is fully up or down, the PTC resistance increases. The resistance returns to normal after voltage is removed from the motor terminals.