Troubleshooting Hints

1. Check Wiper Fuse. If open, check CKT 93 for short to ground.
2. If Washer does not operate, check that:

- Washer Reservoir is filled.
- Hoses are correctly attached.
- Hoses are not cut, kinked or pinched.
- Nozzles are not clogged.
- Connector seal at Washer Motor is not damaged or missing.

3. If Washer does not operate and Wipers run in "HI" only (low speed inoperative), check CKT 91 for open.
4. Check for binding or broken Wiper Arm Linkage.
5. Check for missing or damaged connector seal at Windshield Wiper Motor Module.

^ Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove "GOOD" in a continuity/voltage check.
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems.