Accessory Switch Panel and Switch Opening Cover Assembly

Note:If the vehicle is equipped with side window, mirror selector or door lock switches (92, 93, and 94, or 218), it will have a panel assembly (92). If the vehicle is not equipped with any of these switches, then it will have a cover assembly. Both parts are removed in the same way.

NOTICE: When removing the panel assembly, the ignition switch must be in the "OFF" position and retained accessory power (RAP) must not be present. This will eliminate the possibility of shorting out the switch if a screwdriver, awl or metal object is used.

Accessory Switch Panel Assembly (Typical)-(Chevrolet):

Front Side Door Assembly (Chevrolet):

Front Side Door Assembly -Legend:

REMOVE OR DISCONNECT
1. Front side door inside handle bezel.
2. Panel assembly (92) or cover assembly.
^ Squeeze metal clips to release from handle bezel.
3. Inspect clips for proper position.
4. Remove switches, if equipped and panel assembly is being replaced.

INSTALL OR CONNECT
1. Panel assembly (92) or cover assembly.
^ Install switches if removed. Position panel assembly (92) or cover assembly and press to secure clips.
2. Front side door inside handle bezel.