Troubleshooting Hints

PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS
1. Check Hatch Fuse for open.
2. If Console Deck Lid Re ease Switch is inoperative, check for proper alignment of the Transmission Position Switch (Automatic Transmission Only).
3. Check for a clean and tight ground G401.
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems (Refer to General Troubleshooting Procedures). Diagnostic Aids
^ Refer to System Diagnosis. [1][2]Symptom Table