Mechanical Specifications

Component Torque/Ft. Lbs

Accessory Bracket Bolt 25
Camshaft Retainer Bolt 9
Camshaft Sprocket Bolt 21
Connecting Rod Cap Nut [05]
Camshaft Sprocket Bolt 21
Catalytic Converter To Exhaust Manifold Nuts 21
Coolant Sensor 17
Crankshaft Damper To Hub Bolts 63
Crankshaft Hub Bolt 74
Crankshaft Rear Seal Retainer Bolt & Nut 11
Cylinder Head Bolts [04]
Distributor Bolts 9
EGR Opening Cover Nut [01] [06] 18
EGR Solenoid Bracket Nut 25
EGR Valve Bolt 16
Engine Front Cover Bolt 8
Engine Mount Stud Nuts 40
Engine Mount Through Bolts 77
Engine Oil Galley Plug 18
Exhaust Manifold Bolt/Stud 26
Flywheel Bolt 74
Fuel Pump/Sending Unit To Fuel Tank [01] 45
Fuel Rail Bolt 15
Ignition Distributor Bolt 8
Intake Manifold Bolt/Stud [07]
Knock Sensor 14
Main Bearing Cap [02]
Oil Filter Adapter Bolt 17
Oil Level Sensor 16
Oil Pan [03]
Oil Pan Baffle Nut 25
Oil Pan Drain Plug 16
Oil Pressure Fittings (Plus Alignment) 7
Oil Pressure Sensor/Switch 9
Oil Pump Cover 7
Oil Pump Stub Shaft Bolt 13
Oil Pump To Rear Main Bearing Cap 65
Oil Temperature Sensor 9
Purge Solenoid Bracket Nut 25
Rocker Arm Stud 50
Spark Plug 11
Starter Motor Mounting Bolts 34
Thermostat Housing To Water Pump 8
Throttle Body To Intake Manifold 19
Valve Lifter Retainer 15
Valve Rocker Arm Cover 6
Valve Rocker Arm Nut [06] 18
Water Pump Driven Gear Retainer 9
Water Pump To Engine Bolt 35

[01] Inch lbs.
[02] 1994-95 models, inboard bolts, 78 ft. lbs.; all others, 68 ft. lbs. 1996 models, all bolts 77 ft. lbs.
[03] Corner bolt/nut to 17 ft. lbs.; side rail bolts to 8 ft. lbs.
[04] Refer to Cylinder Head Assembly/Service and Repair for tightening procedure and sequence.
[05] 1994-96 models, tighten in two steps: first step, torque to 20 ft. lbs.; second step, tighten an additional 55°.
[06] VIN 5.
[07] Tighten in two steps: First step, to 6 ft. lbs.; then to 35 ft. lbs.