Brake Light Switch: Service and Repair

1. Remove lefthand lower trim panel as follows:
a. Remove retainer securing lower trim panel to stud on steering column.
b. Remove trim panel mounting screws, then the trim panel.
c. Remove DLC connector assembly mounting screw, then disconnect courtesy lamp electrical connector.
2. Remove stop lamp electrical connectors, then the vacuum hose for cruise control switch.
3. Depress retainer tabs and remove switch from bracket.
4. Reverse procedure to install, noting the following:
a. With brake pedal depressed, insert switch assembly into bracket until seated. Audible clicks can be heard as threaded portion is pushed through bracket toward brake pedal.
b. Pull brake pedal fully rearward against pedal stop until click sounds are not heard. Switch will move in retainer, providing adjustment.
c. Repeat steps a and b until click sounds are not. heard.