Knock Sensor (KS) Module (Inside PCM)

Knock Sensor (KS) Module:

Knock Sensor (KS) Module Removal:

REMOVE OR DISCONNECT

1. Wiring harness from Powertrain Control Module (PCM).
2. Mounting bracket from PCM.
3. Access cover from PCM.

Important: Do NOT remove any other screws.

Removal of the plug-in Knock Sensor (KS) module can be accomplished by two methods as illustrated.

Method 1:

1. Apply two opposing forces on either side of the latch mechanism as shown and pull unit up from the header. Reinstallation accomplished by pushing the unit toward the header.

Method 2:

2. Apply force toward the plug-in KS module with the thumb or forefinger with an opposing force on the opposite side of the module as shown below. Reinstallation is done as stated in Method 1.