Manifold Pressure/Vacuum Sensor: Service and Repair

MAP Sensor Location:

REMOVE OR DISCONNECT
1. Disconnect the MAP sensor electrical connector.
2. Remove the hold down bolts (3).
3. Remove the MAP sensor (1) from the intake manifold.


INSTALL OR CONNECT
1. Install the new MAP sensor seal (2), lightly coated with clean engine oil.
2. Install the MAP sensor (1) to the intake manifold.
3. Install the Hold down bolts (3). Tighten the MAP sensor bolts to 6 Nm (50 lb in).
4. Connect the MAP sensor electrical connector.