Backup Lamp Replacement (USA)

REMOVAL PROCEDURE

Backup Lamp Replacement (Assembly): Removal Procedure:

1. Remove the rear license frame. Carefully depress the locking tabs with a flat-bladed screwdriver.
2. Remove the rear license plate.
3. Remove the backup lamp assembly (w/ rear license bracket) retaining screws.
4. Partially remove the backup lamp assembly to expose the backup lamp sockets.
5. Remove the backup lamp sockets from the backup lamp assembly.
6. Remove the backup lamp assembly (w/ rear license bracket) from the vehicle.

INSTALLATION PROCEDURE

Backup Lamp Replacement (Assembly): Installation Procedure:

1. Install the backup lamp sockets to the backup lamp assembly (w/ rear license bracket).
2. Install the backup lamp assembly into position on the vehicle.
3. Install the backup lamp assembly (w/rear license bracket) retaining screws.

Tighten
Tighten the backup lamp assembly (w/ rear license bracket) retaining screws to 2 N.m (18 lb in).

NOTE: Refer to Fastener Notice in General Information.

4. Install the rear license plate.
5. Install the rear license frame.
Align the locking tabs, then push to lock.