Enabling the Park Brake Automatic Adjuster

ENABLE PROCEDURE
1. Connect the park brake cable to the park brake lever.
2. Remove the rivet, drill bit, zip tie, cotter key from the park brake lever.
3. Install front floor console. Refer to Instrument Panel, Gauges, and Warning Indicators.
4. Raise the vehicle.

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

5. Install the tire and wheel assembly.

Tighten the wheel nuts in sequence to 140 Nm (100 ft. lbs.).

6. Lower the vehicle.
7. Cycle the park brake lever up and down three times for auto adjustment.