M49 Manual Transmission

REMOVAL PROCEDURE





1. Raise and suitably support the vehicle.
2. Disconnect the speed sensor electrical connector.





3. Remove the speed sensor bolt.
4. Remove the speed sensor.
5. Remove the speedometer driven gear, if necessary.

INSTALLATION PROCEDURE





1. Install the speedometer driven gear, if necessary.
2. Install the speed sensor.
3. Install the speed sensor bolt.
^ Tighten the speed sensor bolt to 10 Nm (89 inch lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.





4. Connect the speed sensor electrical connector.
5. Lower the vehicle.