Manual Programming (Domestic/Canada Only)

1. Using a Tech 2, select New BCM Setup and program the BCM with the correct RPO code configuration.
2. Turn ON the ignition leaving the engine OFF for 11 minutes.
3. Turn OFF the ignition for 30 seconds.
4. Turn ON the ignition leaving the engine OFF for 11 minutes.
5. Turn OFF the ignition for 30 seconds.
6. Turn ON the ignition leaving the engine OFF for 11 minutes or until DTC P1630 sets.
7. Turn OFF the ignition for 30 seconds.
8. Turn ON the ignition leaving the engine OFF and wait 30 seconds.
9. Attempt to start the engine. If the engine does not start, Refer to the Powertrain OBD System Check in Engine Controls.

Important: Performing this procedure may cause a DTC P1630 to set. If a DTC P1630 sets, turn OFF the ignition for 30 seconds, then turn ON the ignition. If the DTC P1630 does not clear, Refer to Powertrain OBD System Check in Engine Controls.

TECH 2 TO TECHLINE TERMINAL
1. Using a Tech 2, select New BCM Setup and program the BCM with the correct RPO code configuration.
2. Enter the Service Programming System (SPS) using a Tech 2.
3. Enter the vehicle information.
4. Choose the Request Info soft key on the Tech 2.
5. Select Done.
6. Follow the instructions on the Vehicle Set-up screen.
7. Disconnect the Tech 2 from the vehicle.
8. Connect the Tech 2 to the Techline terminal.
9. At the Techline terminal select SPS and select terminal to Tech 2 programming method.
10. Select Done.
11. Follow the instructions on the remaining screens.
12. Select the Vehicle Theft Re-learn option.
13. Select Program at the summary screen. The terminal will download information to the Tech 2.
14. Return the Tech 2 to the vehicle.
15. Connect the Tech 2 to Diagnostic Link Connector (DLC).
16. Select Service Programming from the Tech 2 main menu.
17. Answer the prompts regarding the model year and vehicle type.
18. Press the Theft Re-learn soft key on the Tech 2.
19. Follow the instructions on the remaining screens.
20. Attempt to start the engine. If the engine does not start, Refer to the Powertrain OBD System Check in Engine Controls.

Important: Performing this procedure may cause a DTC P1630 to set. If a DTC P1630 sets, turn OFF the ignition for 30 seconds, then turn ON the ignition and P1630 clears. If the DTC P1630 does not clear, Refer to Powertrain OBD System Check in Engine Controls.

TECHLINE TERMINAL TO VEHICLE (NO TECH 2)
1. Using a Tech 2, select New BCM Setup and program the BCM with the correct RPO code configuration.
2. Enter the SPS using a Techline Terminal (T-50/T-60).
3. Select terminal to vehicle programming.
4. Select Done.
5. Follow the instructions on the Vehicle Set-up screen.
6. Select the Vehicle Theft Re-learn option.
7. Follow the instructions on the remaining screens.
8. Attempt to start the engine. If the engine does not start, Refer to the Powertrain OBD System Check in Engine Controls.

Important: Performing this procedure may cause a DTC P1630 to set. If a DTC P1630 sets, turn OFF the ignition for 30 seconds, then turn ON the ignition. If the DTC P1630 does not clear, Refer to Powertrain OBD System Check in Engine Controls. Computers and Control Systems